Skip to content
Airleaf

City report · Czechia

Pilsen Air quality today

Air quality in Pilsen currently reads AQI 53 (Moderate): Unusually sensitive people should consider limiting long outdoor exertion.

Air quality right now

AQI 53

Moderate

Main pollutant: PM2.5
PM2.5, fine particles (µg/m³)
10.3
tree cover
28.2%
trees in this area
88.5K
more trees needed
5.6K

Measured across a 2 km radius around Pilsen 3, Czechia (12.57 km²), from a satellite image of Sep 6, 2026. Lower AQI is better: 0–50 is Good, above 300 is Hazardous.

Pilsen · AQI 53 (Moderate)

Dark green marks tree cover detected inside the study radius.Sentinel-2 L2A (ESA Copernicus) via Earth Search, captured Sep 6, 2026

Pilsen's tree count comes to 88,504 trees across 12.56 km² of land, 2 points below the 30% tree-cover level considered healthy for this area, so roughly 5,649 more trees would close the gap.

Air quality detail

Air quality in Pilsen today: AQI 53, Moderate

Main pollutant: PM2.5 · Observed Nov 11, 14:00 local time via World Air Quality Index Project ground stations, US EPA index. Values in µg/m³.

Ground station · Plzen-Doubravka, Plzensky, Czech Republic, 4 km away

Health signal

Unusually sensitive people should consider limiting long outdoor exertion.

PM2.5

10.3

PM10

9.7

NO₂

—

O₃

—

SO₂

—

CO

—

Data: World Air Quality Index Project, Czech Hydrometeorological Institute (Český hydrometeorologický ústav)

Outdoor exercise
Fine for most people; unusually sensitive people should take long or hard exercise easier
Windows
Fine to open; close them if you are sensitive to pollution
Mask
Not needed for most people
Air purifier
Worth running if you are sensitive

Over the last 7 days, the CAMS air-quality model put Pilsen's daily AQI at 82 on average, from 58 on Nov 4 to an hourly peak of 152 on Nov 8.

Last 7 days · model estimateavg 82 · peak 152
Nov 4: AQI 58 (peak 64)Nov 5: AQI 63 (peak 82)Nov 6: AQI 79 (peak 100)Nov 7: AQI 86 (peak 127)Nov 8: AQI 104 (peak 152)Nov 9: AQI 94 (peak 148)Nov 10: AQI 87 (peak 112)
Nov 4Nov 10

Where Pilsen stands: the most polluted cities in the world right now · the cleanest

Tree cover detail

Tree cover in Pilsen: Below target

28.2% tree cover against a 30% healthy-neighborhood target, across 12.56 km² of land.

2 points below target

Trees in this area

88,504

Target trees

94,153

More trees needed

5,649

CO₂ if planted / yr

124.3 t

Deforestation · 2001–2025

How much forest has Pilsen lost?

Since 2001, the area within 10 km of Pilsen has lost about 1,090 hectares of forest (about 1,500 football pitches): 12% of the forest it had in 2000. Most of it was lost to logging, so much of it can grow back. About 139 hectares (13%) was deforestation: forest cleared for good for farms, mines or towns.

Satellite image of the area around Pilsen, August 2017

2017: satellite photo from August 2017 of a 5 × 5 km area about 7 km southwest of the city center.

Forest lost since 2001
1,090 haabout 1,500 football pitches
Share of its forest
12%of what there was in 2000
Cleared for good
139 hadeforestation: turned into farms, mines or towns

Forest loss has stayed about the same: about 66 hectares a year in 2021–2025, against 64 hectares a year in 2016–2020. The worst year was 2021, when about 121 hectares of forest were lost.

Forest lost each year around Pilsen, 2001–2025

Hectares of forest lost each year

Forest lost each year around Pilsen, 2001–2025. Use the left and right arrow keys to read each year.121

Show the figures as a table
Forest lost each year around Pilsen, 2001–2025
YearCleared for goodCan grow backTotal
2001under 1 ha9 ha9 ha
20023 ha36 ha39 ha
20033 ha3 ha6 ha
20046 ha48 ha54 ha
20052 ha22 ha24 ha
20067 ha20 ha27 ha
20074 ha40 ha44 ha
20082 ha47 ha49 ha
200914 ha30 ha44 ha
2010under 1 ha9 ha10 ha
20115 ha30 ha35 ha
20124 ha25 ha29 ha
20137 ha10 ha17 ha
20142 ha33 ha35 ha
20153 ha15 ha17 ha
20164 ha35 ha38 ha
20175 ha35 ha40 ha
201813 ha38 ha51 ha
20196 ha81 ha88 ha
202013 ha91 ha103 ha
20216 ha115 ha121 ha
202212 ha56 ha68 ha
20238 ha45 ha52 ha
20246 ha46 ha52 ha
20255 ha33 ha38 ha

What is causing deforestation around Pilsen?

  • Loggingcan grow back86% · 942 ha
  • Towns and roadscleared for good11% · 123 ha
  • Mining and energycleared for good1.4% · 15 ha

Also: farms, pasture and plantations, unknown causes.

Causes for 2025 are estimates, based on what caused forest loss in the same places up to 2024.

Forest gained and lost, 2000–2020

Forest in 2000
11,700 ha
Forest in 2020
11,900 ha
Overall change
+167 hamore forest than in 2000

Comparing satellite maps from 2000 and 2020, the forest around Pilsen stayed about the same size, at about 11,900 hectares: new forest grew on about 356 hectares, and about 188 hectares were lost.

These 2000 and 2020 maps, from the University of Maryland, count any land with trees taller than 5 m as forest, including plantations and orchards. Forest that was cut or burned and had grown back by 2020 counts in both years, so the loss here is smaller than the yearly figures.

These figures cover everything within 10 km of the city center, a wider area than the report above, because forest is usually lost at a city's edges.

Source: Hansen/UMD/Google/USGS/NASA, Global Forest Change (GFC-2025-v1.13); causes: WRI/Google DeepMind drivers of forest loss; both CC BY 4.0, summed by Airleaf for each area. Forest gained and lost 2000–2020: Potapov et al. 2022, UMD GLAD Global Land Cover and Land Use Change, CC BY 4.0. Images: contains modified Copernicus Sentinel data. How it's measured

In the same region

Measured cities near Pilsen

Same 2 km radius, same index — so they compare directly.

  • Prague

    Czechia

    83.7 km
    Tree cover
    26%
    Air quality
    67
    Compare with Pilsen
  • Regensburg

    Germany

    123.1 km
    Tree cover
    29%
    Air quality
    111
  • Chemnitz

    Germany

    125.1 km
    Tree cover
    41%
    Air quality
    15
  • Dresden

    Germany

    147.2 km
    Tree cover
    33%
    Air quality
    52
  • Gera

    Germany

    156.0 km
    Tree cover
    48%
    Air quality
    46
  • Liberec

    Czechia

    164.6 km
    Tree cover
    47%
    Air quality
    34

Build your own

Compare Pilsen with anywhere

This place

Pilsen

Use this data

Put Pilsen's numbers on your site

Free to embed. Updates itself as the measurement refreshes.

Pilsen air quality (AQI) and tree cover — measured by Airleaf
HTML
Markdown

Frequently asked

Questions about Pilsen

What is the air quality (AQI) in Pilsen right now?

The latest reading for Pilsen shows an AQI of 53 (Moderate), measured Nov 11, 14:00 local time by the Plzen-Doubravka, Plzensky, Czech Republic ground monitoring station, 4 km away, via OpenAQ. The main pollutant is PM2.5. Unusually sensitive people should consider limiting long outdoor exertion.

Is it safe to exercise outside in Pilsen today?

At AQI 53 (Moderate): fine for most people; unusually sensitive people should take long or hard exercise easier. Windows: fine to open; close them if you are sensitive to pollution. Masks: not needed for most people. The reading changes through the day, so check again before a long run or ride.

What has the air quality in Pilsen been like this week?

Over the last 7 days, the CAMS air-quality model put Pilsen's daily AQI at 82 on average, from 58 on Nov 4 to an hourly peak of 152 on Nov 8. On 1 of those days the average was above 100, unhealthy for sensitive groups.

How much forest has the area around Pilsen lost since 2001?

Since 2001, the area within 10 km of Pilsen has lost about 1,090 hectares of forest (about 1,500 football pitches): 12% of the forest it had in 2000. Most of it was lost to logging, so much of it can grow back. About 139 hectares (13%) was deforestation: forest cleared for good for farms, mines or towns. Forest loss has stayed about the same: about 66 hectares a year in 2021–2025, against 64 hectares a year in 2016–2020. Comparing satellite maps from 2000 and 2020, the forest around Pilsen stayed about the same size, at about 11,900 hectares: new forest grew on about 356 hectares, and about 188 hectares were lost.

What is the tree count in Pilsen?

Pilsen has an estimated 88,504 trees across the 12.56 km² of land measured — 28.2% tree cover, 2 percentage points short of the 30% tree-cover target set for this area.

How many more trees does Pilsen need?

Pilsen needs roughly 5,649 more trees to close a 2-point shortfall against its 30% tree-cover target — about 124.3 t of extra CO₂ absorbed per year once grown.

How are Pilsen's air quality and tree cover measured?

Air quality is measured by ground monitoring stations near Pilsen 3, via OpenAQ; the 7-day trend is the Open-Meteo / CAMS model's estimate. Tree cover is measured from Sentinel-2 L2A (ESA Copernicus) via Earth Search satellite imagery at 10 m detail across a 2 km radius around Pilsen 3; the tree count is an estimate derived from that cover.

See your own area

What does your neighborhood look like?

Pick any point and radius to get the same air-quality and tree-cover breakdown.

Check my address